FABLAB_BOT_00 Soldering instructions
![overview](overview.jpg)
Place the LDO and slider switch on the circuit board and solder them.
![step1b](step1b.jpg)
Place the vibration motor on the board.
![step2b](step2b.jpg)
![step3](step3.jpg)
Verify the capacitor before soldering it!
![step4b](step4b.jpg)
Now it’s time to shorten all those long leads.
![step5a](step5a.jpg)
Caution! Hold the pins before cutting them to prevent them from flying everywhere!
![step5b](step5b.jpg)
Make sure everything looks clean and verify that there are no short circuits.
![step6](step6.jpg)
Now it’s time to charge the bot for the first time.
![step7](step7.jpg)